What you will do
- Measure mold/die inserts using Mitutoyo QM-Data 200, Linear Height-LH600 etc.,
- Generate inspection checklist using Mitutoyo CMM Crysta C series and above
- To handle measurement equipment: Micrometer, vernier caliper, dial indicator, Digi height gauge, block gauge, hardness tester
- Ensure all in-house quality standards are met according to GD&T and Molex standard.
- Support and prioritize urgent job requirements as and when required.
- Responsible collecting tooling's from the warehouse and perform GR in Coupa
- Accountable for the tooling parts storage inventory system.
- Maintain housekeeping and adhere to safety regulations to ensure a safe working environment.
- Ensure all the tooling inspection equipment is maintained and calibrated under Quality Management System procedures.
- Other duties as assigned by Management.
Who you are (Basic Requirement)
- NTC 2
- 1 years working experience in toolroom Lab
- Hands on experience using Equipment: Micrometer, vernier caliper, dial indicator, Digi height gauge, block gauge, hardness tester
- Toolmaker scope MF series, CMM, liner height master and surface tester
What will put you ahead (Preferred Requirement)
- Geometric Dimensioning and Tolerancing (GD&T) certification
- 2-3 years' working experience in toolroom Lab and measuring equipment